Dying (The Exciting Part)

Before you can submerge your fabric into the dye pot, you need to wet your fabric so it will absorb the dye better. Make sure your fabric is completely submerged so it doesn't come out spotty. Let it heat in the pot for at least 20 minutes, stirring frequently. After 20 minutes, turn the heat off and let it sit overnight. The fabric would need to sit for hours to let the fabric actually absorb the dye, so one of my group members offered to stay after school to check on the fabric.


Comments

Post a Comment

Popular posts from this blog

Post Dying

Image
Several hours later, I took my fabric out and rinsed it thoroughly as I took my rubber bands off. After all the rubber bands were out, I rinsed my fabric again to make sure I didn't leave any residue from the blackberries. I let my fabric dry for a few days until I was able to iron it. This took about 10 minutes.
Read more

Creating My Design

Image
I used around 25 rubber bands to compress my fabric so the dye wouldn't reach that specific area. I started by using a section towards the middle to make the biggest circle. I put my finger where I wanted the center of the circle to be and starting wrapping a rubber band at the tip of my finger. After that, I took out my finger to continue wrapping the rubber bands further down until I was done with each section. I made about six of these patterns. This took about 10 minutes.
Read more